Note: apply to surfaces above 50 degrees F (10 degrees C). Save instructions for damage-free removal or visit. Important: Failure to follow instructions carefully may cause damage. Stretch straight down along wall at least 15 inches (38 cm) until base and strip release. Hold base gently to prevent base from snapping fingers. Slide hook up to remove from mounting base.ģ. Important: for maximum holding strength slide hook off.ġ. Clean surface with isopropyl rubbing alcohol, wipe gently, let dry. Just don't go too stealth, you might end up pulling the paint off the wall! After which you might as well nail up a real shelf.1. Anyway, the CONCEPT of this post gets an A+, just modify to suit your needs.
In fact if it is the pseudo bathroom tile Masonite you have lines to go by:) Now, forgo those handy clips and just drill a hole through the Masonite ( one sheet at a time before taping together) using your pocket knife in a twisting back and forth motion ( be sure your knife is a lock blade, or if you use that fancy Swiss Utility knife you be extra careful, they like to fold up on your fingers when used this way, so the secret is keep the knife at such an angle to NOT fold on your fingers). score a couple of pieces of the Masonite the same size, 3 if you want it even more sturdy, stack these cut pieces and tape together.
fake tile paneling used in cheap bathroom rebuilds 30 years ago, but now that tuition has gone through the ceiling and kids somehow can afford the posh gentrified 'remodels' these dumps used to be.they rip it out! Find that dumpster -) and use your pocket knife, kitchen paring knife, or cheap plastic break-off-blade utility knife like used for 911. I'd forgo that tiny clipboard and use any scavenged piece of Masonite (ie. On dual shelves, investigate the center hooks, as these are the main failure point, and consider using heavy duty adhesive command hooks on these. Any mis-step in applying even one of these pads can result in shelf failure. If you do hear cracking, remove the shelf and check the adhesive pads. If you do not hear a cracking noise, and your shelf remains intact, then you are ready to use the shelf. Place a weight that is 10-20 percent larger than what you intend to put on the shelf, and leave it for a minute.
However, before going above this figure, or 25 pounds of weight for dual shelves, remember to stress test the wall. On a flat or conventionally painted wall with heavier duty adhesive, the wall's the limit. My shelf, mounted on a textured wall with medium adhesive command hooks, was able to support a 12 pack of lipton teas, or around 12.5 pounds. To remove, simply pull off the shelf, push the hooks up to reveal the underside, and slowly pull on the tab. If you did it right, it will look like the picture. Simply place the board on the command hooks with the duct tape tubes in between the hook and the base of the hook, and attach the string to the upper hooks.
0 kommentar(er)
